Licensed & Insured in MA

Roof Heat Cable Installation in North Reading & the North Shore

Heat cables installed along your eaves, gutters, downspouts and valleys by a local roofer on Elm Street in North Reading. Greg often does the inspection himself, and every estimate is free and in writing.

Get a Free Heat Cable Estimate
Black heat cable clipped in a zig-zag along the edge of a shingle roof and run into the gutter, with a ladder leaning against the gutter below

What does heat cable installation include?

Heat cable installation starts with finding where ice dams form on your roof. We then install UL-listed roof and gutter cable in a zig-zag along the eaves and run it through the gutters, down the downspouts and into valleys, clipped so shingles and flashing aren't damaged. Last, we check that the gutters and downspouts drain.

  • An inspection of where ice dams and icicles form on your house
  • Cable laid out in a zig-zag along the eaves to cover the overhang
  • Runs through the gutters, down the downspouts and partway up valleys
  • The clips the manufacturer specifies, with no nails or staples through the roof
  • A check that gutters and downspouts are clear and draining
  • UL-listed cable rated for roofs and gutters, installed per the manufacturer's instructions
About the electrical side: plug-in cable needs a suitable outdoor outlet with ground-fault protection, and it plugs in directly. An extension cord must never be used. Hardwired systems, new outdoor outlets and new circuits are electrical work, and in Massachusetts that means a licensed electrician. We install the cable on the roof and gutters. We don't do the electrical work.
Request a Free Estimate
Heat cable zig-zagging along the eave of a lower shingle roof where it meets a gray two-story wall, with more cable along the upper roof's eave

Where do heat cables go on your roof?

Every roof is different, so the layout follows your roof's shape, its overhang and the manufacturer's instructions for the cable. On most North Shore houses, cable goes in these places:

  • Eaves: a zig-zag along the lower edge, far enough up to cover the overhang where ice dams start
  • Gutters: a run along the bottom so the gutter doesn't fill with ice
  • Downspouts: all the way down, so water doesn't freeze inside and back up
  • Valleys: a run partway up to keep that channel draining

We usually focus on the trouble spots: a valley that ices up every year, a low porch roof, or a shaded gutter on the north side. A gutter that sags or pulls away will hold water even with cable in it, so if yours need work first, our gutter services team can handle that too. For a deeper look at layout and cable types, read our guide to roof heat cables for ice dams.

Heat cable in a zig-zag along the lower roof edge of a yellow house, seen from an upper roof above a stone patio

Why install heat cables before the snow?

Cable has to be clipped right at the roof edge, and that work is best done while the roof is dry and safe to stand on. Once snow and ice cover the eaves, the clips can't be placed properly and the job gets riskier. Cables also have minimum installation temperatures, so waiting for the first storm doesn't help.

Timing matters after the install, too. Heat cables need to be switched on before snow and ice build up. Cable turned on after a thick dam has formed is not designed to clear it. Before the season starts, it's also worth clearing the gutters and checking the rest of the roof. Our fall roof checklist for North Reading homes walks through it.

Do heat cables fix ice dams for good?

Not on their own, and we'd rather tell you that up front. Heat cables keep drainage paths open. They melt channels through the snow and ice along the eaves, gutters, valleys and downspouts so meltwater drains off the roof instead of refreezing at the cold edge. In the areas they cover, that can stop ice dams from forming.

What they don't do is clear the whole roof or fix the reason the snow is melting. Ice dams start with house heat leaking into the attic through air leaks and thin insulation. Air sealing, insulation and ventilation are the long-term fix, and our guide on how to prevent ice dams on your Massachusetts roof explains them. If your roof is due for replacement anyway, a metal roof sheds snow instead of holding it.

Where heat cables earn their place is the spot that keeps icing up after the attic work, or as a stopgap until that work gets done. On the estimate visit, Greg will tell you which situation you're in. You can see our other roofing work on the all roofing services page.

Zig-zag heat cable along the eaves of a lower shingle roof and the upper roof of a gray two-story house

How does our heat cable installation work?

  1. Inspect. We look at where ice dams, icicles and leaks have shown up, and at the condition of the shingles, gutters and downspouts.
  2. Recommend. We tell you where cable makes sense, whether gutter or attic work should come first, and whether you'll need an electrician for an outlet. You get a free written estimate.
  3. Install. We clip UL-listed roof and gutter cable along the eaves, gutters, downspouts and valleys per the manufacturer's instructions, then check that everything drains.
  4. Walk you through it. We show you where the cable runs, how it gets switched on, when to turn it on, and what to check each fall.

Greg's Construction Co has installed 500+ roofs across North Reading and the North Shore. We're a certified Drexel Metals installer, and we're licensed and insured with general liability and workers' comp.

"We have had Greg's Construction replace our roof, roof repair when roof damage occurred, and also help with ice dams. We have had great service for many years and would highly recommend Greg and his company. Greg and his staff are professional and a pleasure to work with."

Rosemarie Zakrzewski, Google Review
Get a Free Heat Cable Estimate

Heat cable installation questions

Will heat cables melt all the snow off my roof?

No. They melt channels through the snow and ice along the eaves, gutters, valleys and downspouts so meltwater can drain away. The rest of the snow stays on the roof until it melts or slides off.

Do I need an electrician?

Sometimes. Plug-in cable needs a suitable outdoor outlet with ground-fault protection, plugged in directly with no extension cord. If you don't have one, or you want a hardwired system or a new circuit, that's work for a licensed electrician. We install the cable on the roof and gutters, not the electrical work.

When should heat cables go on?

Before the first snow, while the roof is dry and safe to work on. In North Reading that usually means late October or November. They also need to be switched on before snow and ice build up, not after a dam has formed.

Can heat cables go on a metal roof?

Some products are rated for metal roofs and some aren't. Manufacturers generally specify self-regulating cable for metal roofs, but the cable's own instructions decide it. A metal roof already sheds snow well, so we'll also tell you whether you need cable on it at all.

Do you also fix ice dam damage?

Yes. If last winter left lifted shingles, wet decking or leaks, see our roof repair service. We can fix the damage and look at heat cables for the same spot on one visit.

Recent heat cable installs

Photos from recent heat cable installs on asphalt shingle roofs, plus one roof after the first snow.

Close-up of black heat cable zig-zagging along a shingle roof edge to the gutter, with a worker's boots in frame and a ladder below
Zig-zag cable at the roof edge
Heat cable zig-zagging along the eave of a low roof above a back deck, with more cable on the adjoining darker shingle roof
Cable along the eave above a back deck
Heat cable zig-zagging along the roof edge below a dormer on a yellow house
Cable on the roof below a dormer
Snow covering the roofs of a gray two-story house, with a few patches of bare shingle showing near the roof edges
After the first snow

Heat cable and ice dam guides

Read up on how heat cables work and how to stop ice dams before you get an estimate.

How It Works

Getting started with Greg's is easy. Here's what to expect.

01

Call or Request Online

Call Greg at (978) 423-3581 or fill out our contact form. We'll set up a time for Greg to see the roof.

02

Free On-Site Estimate

Greg personally inspects and gives you a detailed written estimate. No pressure, no upselling.

03

Professional Installation

Our experienced crew handles the full job. We protect your property and keep you updated throughout.

04

Final Walkthrough

Greg walks the completed job with you. No open punch list. Your satisfaction is the final sign-off.

Ice dams every winter?

Free written estimates. Call or request online. Licensed & insured in MA.

(978) 423-3581